TY - JOUR
T1 - Diagnostic accuracy of coronary ct angiography
T2 - Comparison of filtered back projection and iterative reconstruction with different strengths
AU - Wang, Rui
AU - Schoepf, U. Joseph
AU - Wu, Runze
AU - Nance, John W.
AU - Lv, Biao
AU - Yang, Hua
AU - Li, Fang
AU - Lu, Dongxu
AU - Zhang, Zhaoqi
PY - 2014
Y1 - 2014
N2 - PURPOSE: To investigate the diagnostic accuracy of coronary computed tomographic (CT) angiography (CCTA) using filtered back projection (FBP) and sinogram-affirmed iterative reconstruction (SAFIRE) of different strength factors with invasive coronary angiography as the reference standard. MATERIALS AND METHODS: Fifty consecutive patients (32 men and 18 women) prospectively underwent electrocardiogram-triggered CCTA on a dual-source CT system. The acquisition window was set depending on the heart rate (HR): HR of less than 60 beats per minute (bpm) at the 70% RR interval, 61 to 80 bpm at 30% to 80% RR interval, and greater than 80 bpm at 30% to 50% RR interval; 100 kV and 359 to 377 mA s for patients with a body mass index of less than 24 kg/m, and 410 to 438 mA s at 120 kV for patients with a body mass index of 24 kg/m or greater. Image data were reconstructed using both FBP and SAFIRE. Sinogram-affirmed iterative reconstruction series were reconstructed using 3 different strength factors. Two blinded observers independently assessed the image quality and image impression of each coronary segment using a 4-point scale (1, non-diagnostic; and 4, excellent). Image noise, signal-to-noise ratio (SNR), and contrast-to-noise ratio (CNR) were measured. Filtered back projection and all SAFIRE series were independently evaluated for coronary artery stenosis (>50%), and their diagnostic accuracy was compared with invasive coronary angiography. RESULTS: Statistically significant increases in SNR and CNR were obtained when higher strength factors were used. The highest SNR and CNR were found with the highest SAFIRE strength factor of 5; however, this strength also resulted in a more unfamiliar, "plasticlike" image appearance. Imaging quality scores of FBP and different SAFIRE strengths were 3.37 ± 0.49, 3.41 ± 0.47, 3.52 ± 0.30, and 3.48 ± 0.35, respectively (P < 0.001). The diagnostic accuracies were 92.91%, 93.76%, 95.28%, and 94.94% on per-segment level, respectively (P = 0.993). A tendency toward higher diagnostic performance was observed with SAFIRE strength factor 3 on per-segment analysis, albeit without reaching statistical significance. The effective radiation dose equivalent was 5.7 ± 1.6 mSv. CONCLUSION: Sinogram-affirmed iterative reconstruction provides significant improvements in image noise, SNR, and CNR compared with FBP, which are progressive with increasing SAFIRE strength factors. Sinogram-affirmed iterative reconstruction strength factor 3 or 5 is recommended for use with CCTA.
AB - PURPOSE: To investigate the diagnostic accuracy of coronary computed tomographic (CT) angiography (CCTA) using filtered back projection (FBP) and sinogram-affirmed iterative reconstruction (SAFIRE) of different strength factors with invasive coronary angiography as the reference standard. MATERIALS AND METHODS: Fifty consecutive patients (32 men and 18 women) prospectively underwent electrocardiogram-triggered CCTA on a dual-source CT system. The acquisition window was set depending on the heart rate (HR): HR of less than 60 beats per minute (bpm) at the 70% RR interval, 61 to 80 bpm at 30% to 80% RR interval, and greater than 80 bpm at 30% to 50% RR interval; 100 kV and 359 to 377 mA s for patients with a body mass index of less than 24 kg/m, and 410 to 438 mA s at 120 kV for patients with a body mass index of 24 kg/m or greater. Image data were reconstructed using both FBP and SAFIRE. Sinogram-affirmed iterative reconstruction series were reconstructed using 3 different strength factors. Two blinded observers independently assessed the image quality and image impression of each coronary segment using a 4-point scale (1, non-diagnostic; and 4, excellent). Image noise, signal-to-noise ratio (SNR), and contrast-to-noise ratio (CNR) were measured. Filtered back projection and all SAFIRE series were independently evaluated for coronary artery stenosis (>50%), and their diagnostic accuracy was compared with invasive coronary angiography. RESULTS: Statistically significant increases in SNR and CNR were obtained when higher strength factors were used. The highest SNR and CNR were found with the highest SAFIRE strength factor of 5; however, this strength also resulted in a more unfamiliar, "plasticlike" image appearance. Imaging quality scores of FBP and different SAFIRE strengths were 3.37 ± 0.49, 3.41 ± 0.47, 3.52 ± 0.30, and 3.48 ± 0.35, respectively (P < 0.001). The diagnostic accuracies were 92.91%, 93.76%, 95.28%, and 94.94% on per-segment level, respectively (P = 0.993). A tendency toward higher diagnostic performance was observed with SAFIRE strength factor 3 on per-segment analysis, albeit without reaching statistical significance. The effective radiation dose equivalent was 5.7 ± 1.6 mSv. CONCLUSION: Sinogram-affirmed iterative reconstruction provides significant improvements in image noise, SNR, and CNR compared with FBP, which are progressive with increasing SAFIRE strength factors. Sinogram-affirmed iterative reconstruction strength factor 3 or 5 is recommended for use with CCTA.
KW - Computed tomography (CT)
KW - Coronary arteries
KW - Image reconstruction
KW - Radiation dose
UR - http://www.scopus.com/inward/record.url?scp=84897051712&partnerID=8YFLogxK
UR - http://www.scopus.com/inward/citedby.url?scp=84897051712&partnerID=8YFLogxK
U2 - 10.1097/RCT.0000000000000005
DO - 10.1097/RCT.0000000000000005
M3 - Article
C2 - 24625599
AN - SCOPUS:84897051712
SN - 0363-8715
VL - 38
SP - 179
EP - 184
JO - Journal of Computer Assisted Tomography
JF - Journal of Computer Assisted Tomography
IS - 2
ER -